This parameter enables the device, when out of range, to hold off on sounding the Virtual Tether alarm to provide an opportunity to re-establish a connection.
Ensure that this setting is not too short in order to avoid the following:
If the cradle resets, it causes the scanner to activate the Virtual Tether alarm.
Noisy RF environments can lead to frequent, momentary disconnect/reconnect sequences.
To set a delay, choose Delay Before Alarm Activates, and then enter the two numeric barcodes from Numeric Barcodes that correspond to the desired timeout duration. Enter a leading zero for single digit numbers.
For example, to set a 5 second page timeout, enter 0 barcode and then 5. To correct an error or change the selection, Cancel.
