Battery Preservation Mode
View content for :
Platform:

Battery Preservation Mode

Parameter #
1765
(SSI # F8h 06h E5h)
Battery Preservation Mode preserves the battery charge when the scanner is not being used for an extended period of time.

Notes

When asleep in Battery Preservation Mode, you cannot access the scanner for remote management.
Set the Battery Preservation Timeout Value to change the amount of time before the battery disconnects from the scanner.
  • Use Enable Battery Preservation Mode to internally disconnect the battery from the scanner when the scanner is unused and not being charged for nine hours (default). In this mode the scanner completely turns off. This preserves the battery charge and significantly extends battery shelf life. To exit Battery Preservation Mode and return to normal operation, press the scanner trigger or return to charging. The scanner cannot scan until the wake-up process completes. This takes a few seconds.
  • Use Disable Battery Preservation Mode to keep the battery connected to the scanner at all times. This prevents the battery from disconnecting from the scanner after nine hours of sitting idle (no scanning) and not charging. Substantial battery shelf life improvements are not gained as when Battery Preservation Mode is enabled.
  • Use Battery Preservation Timeout followed by 3 digits in Numeric Barcodes to select a different battery preservation timeout value (the default is nine hours). For example, to set the preservation timeout value to 12 hours, scan Battery Preservation Timeout, and then scan 0, 1, and 2 in Numeric Barcodes. To correct an error or change the selection, scan Cancel.
*Enable Battery Preservation Mode (9)
Disable Battery Preservation Mode (0)
Battery Preservation Timeout Value