Installing the Linerless Media Cutter
Installing the Linerless Media Cutter

Installing the Linerless Media Cutter

To install the linerless media cutter, you must remove the standard bezel and disconnect DC input power to the printer.  See Removing the Standard Bezel.
  1. Open the printer, remove the standard platen roller, and replace it with the linerless platen roller. See Cleaning and Replacing the Platen. For a list of compatible platen rollers, see Installing the Printhead Resolution Upgrade Kits.
  2. Place the cutter module and printer right side up with the top of the module even with the bottom of the top cover. Center and push the module into the front of the printer and slide it up until it stops.
  3. Turn the printer upside down and attach the module to the printer with the two screws using the Torx wrench.
    For optimal printer performance, update the printer’s firmware after installing options or immediately after the printer’s initial setup. See Updating Printer Firmware.