Loading Roll Media for Cutter Models

Loading Roll Media for Cutter Models

If your printer has the optional cutter module installed, use these instructions to load roll media.
  1. Thread the media through cutter’s media slot and pull it out the front of the printer.
  2. Close the printer. Press down until the cover snaps closed.
You may need a calibrate your printer for the media.  (See Running a SmartCal Media Calibration.) The printer’s sensors must adjust to sense the label, the liner, and the distance between labels to operate properly. When reloading the same media (size, vendor, and batch), you can simply press
FEED
(Advance) once to prepare the media for printing.