Sensors Menu
Sensors Menu

Sensors Menu

This table describes the Sensors menu items.
Sensor Menu Items
Setting
Description, Accepted Values, and Configuration Methods
SENSOR TYPE
Select the media sensor that is appropriate for the media that you are using. The reflective sensor typically is used only for black mark media. The transmissive sensor typically is used for other media types.
Accepted values:
  • TRANSMISSIVE
  • REFLECTIVE
Related ZPL command(s):
^JS
SGD command used:
device.sensor_select
Print Server web page:
View and Modify Printer Settings
Media Setup
LABEL SENSOR
Set the sensitivity of the label sensor.
This value is set during sensor calibration. Do NOT change this setting unless you are told to do so by Zebra Technical Support or by an authorized service technician.
Acceptable values: 0 to 255
SGD command used:
ezpl.label_sensor
Print Server web page:
View and Modify Printer Settings
Calibration
TAKE LABEL
Set the intensity of the label taken sensor circuit.
This value is set during sensor calibration. Do NOT change this setting unless you are told to do so by Zebra Technical Support or by an authorized service technician.
Accepted values: 0 to 255
SGD command used:
ezpl.take_label
Print Server web page:
View and Modify Printer Settings
Calibration