Place one screw in the top adapter mounting hole of both of the roll holders. Turn the screws clockwise using the Torx wrench until the tip of the screw barely protrudes through the inside of the roll holder.
The screws are self-tapping.
Place the adapter on the inside of the roll holder, making sure the large side is on top and the smooth side (no ribs) face the middle of the printer.
Align the adapter’s top screw hole to the protruding screw tip and pinch it tightly to the roll holder body. Tighten the screw until there is no gap between the adapter and roll holder. Do not tighten beyond this point.
Over-tightening will strip the thread.
Insert a screw in the bottom adapter mounting hole. Pinch the adapter tightly to the roll holder while tightening the screw. Tighten the screw until there is no gap between the adapter and roll holder. Do not tighten beyond this point.
Over-tightening will strip the thread.
Repeat the above steps to install the other adapter and roll holder.
1
Label roll with 76.2 mm (3.0 in.) inner core mounted on media core adapters (shown as an example)
