Installing the Internal Ethernet (LAN) Module
Installing the Internal Ethernet (LAN) Module

Installing the Internal Ethernet (LAN) Module

  1. With the DC power plug and module’s access door removed, slide the Ethernet module into the printer. Push the circuit card in slowly but firmly until the card is just past the inside lip of the access door.
  2. Align the bottom of the Ethernet port’s door cover to the bottom lip of the module access opening, then swing the door up and snap the cover closed.
    1
    Ethernet port (RJ-45)
    For best printer performance, update the printer’s firmware after installing options or immediately after the printer’s initial setup. See Updating Printer Firmware.