Serial Port Interface

Serial Port Interface

The ZD620 / ZD420 printer uses Zebra Auto-Detecting DTE and DCE for 9-Pin RS-232 Interface.
Pin
DTE
DCE
Description (DTE)
1
5V
Not used
2
RXD
TXD
RXD (receive data) input to the printer.
3
TXD
RXD
TXD (transmit data) output from the printer.
4
DTR
DSR
DTR (data terminal ready) output from the printer -- controls when the host may send data.
5
GND
GND
Circuit ground.
6
DSR
DTR
DSR (data set ready) input to the printer.
7
RTS
CTS
RTS (request to send) output from the printer -- always in the ACTIVE condition when the printer is turned on.
8
CTS
RTS
CTS (clear to send) - Not used by the printer.
9
5V
+5 V @ 0.75 A - FET Circuit current limited.
The maximum current available through the serial port, USB port or both will not exceed a total of 0.75 Amps.
When XON/XOFF handshaking is selected in the printer driver, data flow is controlled by the ASCII control codes DC1 (XON) and DC3 (XOFF). The DTR control lead will have no effect.

Interconnecting to DTE Devices

The printer is configured as data terminal equipment (DTE). To connect the printer to other DTE devices (such as the serial port of a personal computer), use an RS-232 null modem (crossover) cable. Table 1 shows the required cable connections.
Connecting the Printer to a DTE Device
DB-25S Connector to DTE Device (PC)
DB-9P Connector to Printer
DB-9S Connector to DTE Device (PC)
DB-9P Connector to Printer

Interconnecting to DCE Devices

: When the printer is connected using its RS-232 interface to data communication equipment (DCE) such as a modem, a STANDARD RS-232 (straight-through) interface cable must be used. Table 2 shows the connections required for this cable.
Connecting the Printer to a DCE Device
DB-25S Connector to DCE Device
DB-9P Connector to Printer
DB-9S Connector to DCE Device
DB-9P Connector to Printer