Installing the Attached Power Supply Base Options
Installing the Attached Power Supply Base Options

Installing the Attached Power Supply Base Options

The power base is designed for quick installation using a Torx T10 wrench (that you supply) and mounting screws provided with the upgrade kit.
  1. Remove media rolls (if any) from the printer.
  2. Unplug the power supply cable from the back of the printer.
  3. Turn the printer over, then align the power base to the bottom of the printer with the printer power plug oriented toward the rear side of the printer. The printer’s rubber feet  should align with recesses on the top of the power base.
  4. Use the screws provided to attach the power base to the printer. Thermal Transfer printer models use four screws (A), and Direct Thermal printer models attach to the printer with three screws (B). Tighten the screws using the Torx wrench.
  5. Insert the DC input power plug into the printer.
    1
    DC input power plug
  6. Re-connect the AC power cord to the printer power base.