When installing a new installation, use the DC Power Adapter (p/n CBL-ET6-ADPA2-1), DC/DC Power Supply (p/n PS1370), and the Power Extension Cable (p/n CA1210). Must be used with the ET60 with installed Touch Screen Heater.
Mount the DC/DC Power Supply to the vehicle using four screws (not included).
Install the Power Extension Cable to the vehicle power source. Refer to the CA1210 Power Extension Cable Installation Instructions, MN-002747-01, supplied with the cable.
Connect Power Supply input connector to the Power Extension Cable connector.
Connect Power Supply output connector to the DC Power Adapter connector.
Route the DC Power Adapter DC connector through the bottom access hole in the bottom of the dock.
Plug the DC connector into the Power port.
Secure the cable to a mounting point with a cable tie.
