1. ET6x Product Reference Guide
  2. Vehicle Dock Installation
  3. Power
  4. Replacing Legacy Installations
  5. Replacing an Existing Legacy Installation with PS1370 Power Supply
  • ET6x Enterprise Rugged Tablet Product Reference Guide
Replacing an Existing Legacy Installation with PS1370 Power Supply

Replacing an Existing Legacy Installation with PS1370 Power Supply

When replacing an existing legacy installation with an ET6x installation, use the DC Power Adapter (p/n CBL-ET6-ADPA2-1), and the DC/DC Power Supply (p/n PS1370).
  1. Mount the DC/DC Power Supply to the vehicle using four screws (not included).
  2. Connect Power Supply input connector to the existing power cable connector.
  3. Connect Power Supply output connector to the DC Power Adapter connector.
  4. Open the Vehicle Dock Access Door.
  5. Route the DC Power Adapter DC connector through the bottom access hole in the bottom of the dock.
  6. Plug the DC connector into the Power port.
  7. Secure the cable to a mounting point with a cable tie.
  8. Close the Access Door.