• GS20 Leader Module
Sending Results to the PLC Device
Sending Results to the PLC Device

Sending Results to the PLC Device

To configure a GS20 Leader Module to send scanning results to a PLC.
  1. Navigate to the
    Admin Settings
     screen from the left menu on the
    Home
     screen and click
    PLC Config
    .
  2. Click
    Results Tag
     on the
    PLC Configuration
     screen.
  3. Toggle
    Reset After Trigger
     to the right to reset the results after a trigger event.
  4. Select the
    PLC
     device from the menu, enter a
    Tag to Monitor
    , and enter a
    Trigger Value
    .
  5. On the
    PLC Configuration
     screen, toggle
    Output Via PLC
     to the right to output results to the PLC.
    The results tag supports a string of up to 4096 characters, including the CR+LF terminator.
  6. Once the configuration is complete, return to the
    Control PLC
     screen, select the PLC device from the menu, and click
    Start
     to begin sending results.