GS20 Leader Module

Sending Results to the PLC Device

Configure the device to send scanning results to a PLC.

Navigate to the

Admin Settings

screen from the left menu on the

Home

screen and click

PLC Config

.

Click

Results Tag

on the

PLC Configuration

screen.

Select the

PLC

from the menu and specify a

Results Tag

name.

Click

Apply

.

The

Results Device

and

Results Tag

at the top of the screen update to reflect the new results definition.

The

Results Tag

must match a PLC tag of the same name. For Rockwell PLCs, it is required that the tag a

STRING

of length

4096

. For all other PLC types, the

Results Tag

should be a data block or starting register that has

4096

available bytes after it.

Enable

Output Via PLC

on the

PLC Configuration

screen to allow the Connectivity Gateway to write incoming follower results to the

Results Tag

on the PLC.

The

Results Device

must be active for the Connectivity Gateway to write follower results successfully. Start the PLC device from the

Control PLC

menu.

After the configuration is complete, go to the

Control PLC

screen.

Select the PLC device from the menu and click

Start

to begin sending results.