• GS20 Leader Module
Setting Up TCP/IP Trigger Settings for TCP/IP Triggered Mode
Setting Up TCP/IP Trigger Settings for TCP/IP Triggered Mode

Setting Up TCP/IP Trigger Settings for TCP/IP Triggered Mode

Configure the control port on each of the follower devices accordingly to ensure that the TCP/IP trigger propagates from the GS20 Leader Module to the follower devices.
  1. Using Zebra Aurora Focus, navigate to the
    Communication
     pane and change the
    Control
     section as follows:
    • Control Port Number: 107
    • Control Terminator: CR+LF
    • Trigger String: TRIGGER
  2. Click
    Apply
     in
    TCP/IP Settings
     to ensure that the changes are applied.
  3. Ensure that the Trigger Settings for
    Source
     is set to
    TCP/IP
     and
    Job Mode
     is set to
    Single Shot
     in Capture mode.
Software Overview