Item | Description |
|---|---|
Source | Select the trigger source from GPIO, Device Trigger, Serial, PLC, TCP/IP Auto(Self), Test Trigger |
Job Mode | Select the Job Mode between Single Shot, Level Continuous, Series (Burst), Periodic Single Shot, Continuous, Presentation |
GPIO Inputs | When the Source trigger is set to GPIO, use this drop-down menu to select the GPIO input. This is useful if more than one GPIO is configured as Input. The number corresponds to the GPIO number, and the description is the current configuration of the GPIO, for example:
|
Active Job Timeout | This is the maximum duration for the inspection Job |
Do Not Read Last | Use this option to skip reading the last barcodes. Typically, presentation mode or continuous mode is used to ensure that codes are decoded twice. |
Show Image | Disable this option to speed up the decoding. |
Setting | Description |
|---|---|
Barcode Autotune | Use this button to force an automatic tune procedure that configures the camera to read the barcode or Datamatrix, adjusting. Exposure , Gain Factor and Focus . |
Autotune Settings | Open the dialog to adjust the Autotune Settings. |
Image Perfect+ Setup | The setup list on the left is the possible configuration for Image Perfect+. |
Add Settings | Use this command to add a new setup to Image Perfect+ |
Name | Assign a name for the Image Acquisition Setup |
Exposure | Exposure time in ms. |
Long Exposure | Activate this option to adjust the exposure time from 33 to 750 ms. |
Gain Factor | Use this slider to adjust the sensor gain factor from 0 to 100. |
Focus | Use this slider to adjust the focus length. |
Focus Unit | Select Millimeter, Inch, or Dioptor to configure the focus measurement units on the device. Depending on the hardware version of your device, MIlliimeter and Inch measurements are available in addition to Diopter . While the millimeter and inch distance values calculated in the application may slightly differ from the real-world distance value, this does not impact the device’s performance. |
Aiming Configuration | Enabling this feature projects an aiming pattern onto the surface where the camera is pointing and helps to position the camera by identifying the focal point of the field of view. |
Internal Illumination | This setting can only be enabled with Unrestricted USB Power, PoE, and 24V external power. |
Light Intensity | Use the slider to increase light intensity by sliding to the right.
|
Torch Mode | When enabled, the internal lights of the device are powered with static DC voltage with no strobing or overdrive. The resultant images are not as bright while in Torch Mode. This can be helpful for use cases that do not have movement and necessitate a longer exposure. |
Red Light |
|
External Illumination | External illumination can be activated only when a 24V DC power supply provides the power. |
Light Intensity | This controls the analog voltage pin on the Analog Output Pin.
|
