Waist Holster
Waist Holster

Waist Holster

The ZQ630 Plus printer has a waist holster option allowing you to carry the printer around your waist for easy access.
  1. Unsnap the fastener on the waist strap.
  2. Unlock the male D swivel clip on the waist strap from the female D clip on the printer mount pad to remove it.
  3. Align the holes on the mount pad with the mounting holes on the bottom of the printer (circled).
  4. Use a 4mm hex driver on the two 6-32 x 0.375 in. screws and two #6 washers to attach the mount pad to the top of the printer (circled).
  5. Attach the two 6-32 x 0.625 in. screws and washers to the bottom of the mount pad (circled).
  6. Connect the male D swivel clip on the waist strap to the female D clip on the printer mount pad.
  7. Snap the fasteners to secure (opposite side), and then rotate the waist strap 180°.
  8. Unsnap the waist strap and adjust it to the desired length.
  9. Wrap the waist strap around your waist and snap the fastener in place to secure it.
    The printer hangs comfortably below the hip.