Installing the Keyboard Cable

Two keyboard require installation of a USB cable prior to installation.

For CBL-ET-KBUSB1-01, and CBL-ET-KBUSB2-01 only.

To install the keyboard USB cable:

Remove the four screws securing the cable cover to the keyboard.

Turn the cable connector at a right angle as shown below and insert the connector (with connector clips on top) into the keyboard housing.

1	Keyboard housing
2	Connector clips

Turn the cable connector straight (with connector clips on top) and plug the connector in the keyboard.

Secure the cable retention to the housing using the two retention screws. Torque the M3 screws to 6kgf-cm (5.2 lbs-in).

Gently push the wires downward and install the cable cover. Torque the four M3 screws to 6kgf-cm (5.2 lbs-in).

1	Cable cover with M3 screws (4)