For vehicles with a power source that is 15 VDC or less, a DC/DC Power Supply is not required. Use the Direct Wire Kit to connect the Vehicle Dock to the power source.
Measure the distance from the vehicle power source to the Vehicle Dock power port.
Cut the Direct Wire Kit cable from the DC power plug to length.
Strip the ends of the two wires to 6 mm (0.25 in.).
Strip both ends of the fuse holder wires to 6 mm (0.25 in.).
Using a butt splice connector, connect the red wire to one end of the fuse holder wire.
Connect a ring terminal to the other end of the fuse holder wire.
Connect a ring terminal to the end of the black wire.
Insert the fuse into the fuse holder.
Close the fuse holder cover.
Connect the black wire to the negative power source.
Connect the fuse wire to the positive power source.
Open the Vehicle Dock Access Door.
Route the power connector through the bottom access hole in the bottom of the dock.
Plug the DC connector into the Power port.
Secure the cable to a mounting point with a cable tie.
