Replacing an Existing Legacy Installation with PS1370 Power Supply
Replacing an Existing Legacy Installation with PS1370 Power Supply
Replacing an Existing Legacy Installation with PS1370 Power Supply
When replacing an existing legacy installation with an ET6x installation, use the DC Power Adapter (p/n CBL-ET6-ADPA2-1), and the DC/DC Power Supply (p/n PS1370).
Mount the DC/DC Power Supply to the vehicle using four screws (not included).
Connect Power Supply input connector to the existing power cable connector.
Connect Power Supply output connector to the DC Power Adapter connector.
Open the Vehicle Dock Access Door.
Route the DC Power Adapter DC connector through the bottom access hole in the bottom of the dock.
Plug the DC connector into the Power port.
Secure the cable to a mounting point with a cable tie.
