This section provides an overview of the WAN Antenna (P/N: ANT-4G5GGPS010-SMA), including frequency port mapping and mounting methods.
Antenna Mounting
Mounting
Part
Description
1
WAN Antenna (P/N: ANT-4G5GGPS010-SMA)
2
RF Cables
The antenna contains multiple antenna elements within the single antenna housing. It comes as a complete kit with mounting hardware and a sealing gasket. It has 4 cables attached. Each cable is 1 meter long and has a frequency label to connect it to the correct port on the FXR90, as shown below.
Cables should be fully extended for maximum separation.
WAN Antenna Frequency
Connector
Frequency
LMH (Ant0)
600-5000 MHz
*MH (Ant1)
1100-6000 MHz
LMH# (Ant2)
600-5000 MHz
MH (Ant3)
1400-6000 MHz
Mount the antenna to a flat surface/panel with the nut provided. Hand-tighten the nut. To pole-mount the device, use the mounting bracket.
For optimal performance, use the full cable length with the antenna box above the reader. Secure cables to the mounting surface.
The sides of the antenna box should have a minimum of 304.8 mm (12 in. ) of clearance. The top of the antenna should have no obstruction above to maintain reliable WAN and/or GNSS performance.
