Follow the instructions in this section to connect the DC-DC power supply input (P/N: PWR-BGA24V90W1WW).
Using the threaded circular connector, connect the DC power supply cord (CBL-PWRD150-M12M00).
Make sure the circular connector is fully inserted and screwed down; hand tighten only.
Observe the DC input wire color code
DC Wire Color Code
SIGNAL
CONN 1
COLOR
DC_IN_POS (9-60 VDC)
1
RED
2
RED
DC_IN_NEG
3
BLACK
4
BLACK
ENABLE (DEFAULT ON)
5
BLUE
Grounding the ENABLE signal will disable the unit. Letting it float will enable it. ENABLE should not be connected to a voltage greater than 18 V DC.
Connection should be performed by a qualified professional, following local electrical codes, using certified connectors, wiring boxes, and weatherproof provisions as needed.
