Replacing the Hand Strap

This section describes the method for replacing the expansion back hand strap.

If the PowerPack is installed, remove the PowerPack.

Rotate the disk so that the strap end without the eyelet is aligned with the PowerPack opening.

Open both ends of the hand strap.

Pull the strap end without the eyelet through the slot on the Expansion Back.

Rotate the disk 180°.

Slide the pad off the hand strap.

Pull the eyelet (1) end through the slot (2) on the Expansion Back.

Remove pad from new replacement hand strap.

Rotate the disk (3) so that one of the slots is aligned with the PowerPack opening (4).

Feed the new hand strap (1) through the slot (2) at the PowerPack opening (4).

Slide pad (1) onto hand strap with the stylus holder (2) facing up.

Fold the eyelet end of the strap up and press hook and loop material together.

Rotate disk 180° so that the empty slot is aligned with the PowerPack opening.

Feed strap through the slot.

Fold the end of the strap up and press hook and loop material together.