• GS20 Leader Module
Setting Up GPIO Pass/Fail
Setting Up GPIO Pass/Fail

Setting Up GPIO Pass/Fail

To configure GPIO Pass/Fail on an Out pin of your choice:
  1. Determine which Out to use for Pass/Fail. There are only two outputs on the GS20. The output is used to trigger followers and cannot be used to output scanning results.
  2. Navigate to the
    Configuration
     screen using the left menu on the
    Home
     screen.
  3. Use the top-right
    GPIO Pass/Fail
     section to select Pass and Fail pins.
  4. Click
    Config
     to configure an SD timeout in ms when enabled and click
    Update
    .
  5. Set the toggle to
    Enabled
     and click
    Update
    .