Parameter | Details |
|---|---|
o =
field orientation | Values:
N =
normalR =
rotates 90 degrees (clockwise)I =
inverted 180 degreesB =
read from bottom up, 270 degreesDefault:
N
or the last
^FW
value |
h =
character height (in dots) | Default:
Specifies magnification by
w
(character width) or the last accepted
^CF
value. Uses the base height if none is specified.
|
w =
width (in dots) | Default:
Specifies magnification by
h
(height) or the last accepted
^CF
value. Specifies the base width is used if none is specified.
|
d =
drive location of font | Values:
R:
,
E:
,
B:
, and
A:
Default:
R
: |
f =
font name | Values:
any valid fontDefault:
if an invalid or no name is entered, the default set by
^CF
is used If no font has been specified in
^CF
, font A is used.The font named carries over on all subsequent
^A@
commands without a font name. |
x =
extension.TTE
is only supported in firmware version V60.14.x, V50.14.x, or later. | Values:
.FNT
= font.TTF =
TrueType Font.TTE =
TrueType Extension |

1 | Starts the label format. |
2 | Searches non-volatile printer memory (
B:
) for
CYRI_UB.FNT
. When the font is found, the
^A@
command sets the print orientation to normal and the character size to 50 dots by 50 dots. |
3 | Sets the field origin at 100,100. |
4 | Prints the field data,
Zebra Printer Fonts
on the label. |
5 | Calls the font again and character size is decreased to 40 dots by 40 dots. |
6 | Sets the new field origin at 100,150. |
7 | Prints the field data,
This uses the B:CYRI_UB.FNT
on the label. |
8 | Ends the label format. |