Parameters | Details |
|---|---|
a =
media being used | Values:
N =
continuous mediaY =
non-continuous media web sensing
1, 2
W =
non-continuous media web sensing
,1, 2
M =
non-continuous media mark sensingA =
auto-detects the type of media during calibration
1, 3
V
= continuous media, variable length
4
Default:
a value must be entered or the command is ignored |
b =
black mark offset in dots | This sets the expected location of the media mark relative to the point of separation between documents. If set to 0, the media mark is expected to be found at the point of separation. (i.e., the perforation, cut point, etc.)All values are listed in dots. This parameter is ignored unless the
a
parameter is set to
M
. If this parameter is missing, the default value is used.
Values:
-80
to
283
for direct-thermal only printers-240
to
566
for 600 dpi printers-75
to
283
for KR403 printers-120
to
283
for all other printersDefault:
0 |