Parameters | Details |
|---|---|
a =
condition type | Values:
A =
paper outB =
ribbon outC =
printhead over-tempD =
printhead under-tempE =
head openF =
power supply over-tempG =
ribbon-in warning (Direct Thermal Mode)H =
rewind fullI =
cut errorJ =
printer pausedK =
PQ job completedL =
label readyM =
head element outN =
ZBI (Zebra BASIC Interpreter) runtime errorO =
ZBI (Zebra BASIC Interpreter) forced errorP =
power onQ =
clean printheadR =
media lowS =
ribbon lowT =
replace headU =
battery lowV =
RFID error (in RFID printers only)* =
all errorsDefault:
if the parameter is missing or invalid, the command is ignored |
b =
destination for route alert | Values:
A =
serial portB* =
parallel port C =
e-mail addressD =
TCP/IPE =
UDP/IPF =
SNMP trapDefault:
If this parameter is missing or invalid, the command is ignored. * Requires
bidirectional communication. |
c =
enable condition set alert to this destination | Values:
N =
no Y =
yesValues:
Y
or previously configured value |
d =
enable condition clear alert to this destination | Values:
N =
no Y =
yesValues:
N
or previously configured valueParameters
e
and
f
are sub-options based on destination. If the sub-options are missing or invalid, these parameters are ignored. |
e =
destination setting | Values:
Internet e-mail address (e.g. user@company.com)
IP address (for example, 10.1.2.123)
SNMP trap
IP or IPX addresses
|
f =
port number | Values:
TCP port # (
0
to
65535
)UPD port # (
0
to
65535
) |