This parameter controls scanner cloning through the cradle.
Choose the following:
Enabled - The cradle’s stored scanner parameters are transmitted upon pairing to the cradle, which configures the scanner with updated parameters. This enables the scanner to be automatically configured for a new host application, use case, or workflow.
*
Disabled - Scanner does not auto-configure upon pairing to the cradle.
When AutoConfig (Scanner Cloning Through Cradle) is enabled, scanning is disabled for up to 3 to 5 seconds while the configuration is being uploaded to the scanner. The green LED blinks during this period. Any pre-programmed scanner settings listed above are overwritten and lost once AutoConfig (Scanner Cloning Through Cradle) is performed by pairing the scanner and cradle. AutoConfig (Scanner Cloning Through Cradle) is not supported in Multi-Point.
The cradle’s configuration of the scanner is limited to the following scanner parameters:
