1. Zebra Aurora User Guide
  2. Zebra Aurora Software Overview
  3. Configuring Device Settings
  4. GPIO Mapping
  • Zebra Aurora User Guide
GPIO Mapping

GPIO Mapping

Configure the GPIO on the 12-pin and 5-pin connectors by selecting the GPIO and configuring its direction and signal type. Enable External Illumination mode for the 5-pin connector by specifying its mode.
GPIO Mapping
Setting
Description
Direction
Configure the input signals coming into the device or the output signals sent out from the device.
Select the GPIO port configuration choosing from Input, Output, Static High, and Static Low.
Static High sources the current for an external load. Static Low sinks the current for an external load.
Signal Type
Configure the Signal Type, such as a manual or hardware trigger.
Use the Input signal to connect to a hardware or software trigger.
Use the Output to connect to Job Result, or use it as an External Light Strobe.
Advanced Settings
Use Input to configure Input Debounce and Input Delay.
Use Output to configure Pulse Width and Output Delay.
External Illumination Mode
Toggle this setting to automatically configure the pins in this port to power and control external illumination.