1. Zebra Aurora User Guide
  2. Zebra Aurora Software Overview
  3. Configuring Device Settings
  4. General Settings
  • Zebra Aurora User Guide
General Settings

General Settings

Configure the beeper, power, and LED settings using the
General Settings
 tab. Beeper settings can be set to enable or disable, and the beep's volume, tone, and duration can be configured to fit the needs of a specific use case.
General Settings
Setting
Description
Beeper
Beeper Enable
Enables the beeper on the device.
Beeper Volume
Configures the volume of the beeper.
  • High
  • Medium
  • Low
  • Off
Beeper Tone
Configures the tone of the beeper.
  • High
  • Medium
  • Low
  • Off
Beep on Job Success
When enabled, the device beeps upon successful completion of a job.
Beeper Duration
Configures the tone of the beeper.
  • Short
  • Medium
  • Long
Suppress Power-Up Beeps
When enabled, the power-up warble beeps that sound upon device start-up play at a reduced level.
Power
Unrestricted USB-A Power
When enabled, the device receives unrestricted power from a USB-A power source. This is required to enable full-power internal lighting
Hold Until Next Trigger
When enabled, the 360 LED is held until the device is triggered again.
Parameter Barcode
Enable Parameter Barcodes
When enabled, the device configuration can be changed using a barcode
360 LED
Number of Flashes
Use the slider to configure the number of flashes the LED illuminates upon decode.
Time per Flash
Use the slider to configure the number of times in ms the LED illuminates upon decode.