1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  3. SGD RFID Commands
  4. rfid.reader_1.antenna_port
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
rfid.reader_1.antenna_port

rfid.reader_1.antenna_port

This command specifies the RFID antenna to be used for RFID operation.
  • This applies only to ZT400 and ZT600 series RFID printers, which have multiple antenna elements. Other printers, which only have one antenna element, always use an antenna element value of
    A1
    .
  • Printers automatically select the best antenna element and read/write power levels for the media during RFID transponder calibration. The ZT400 and ZT600 series printers also may set the levels during an adaptive antenna sweep. Use ^HL or ~HL to view the antenna element and power settings being used.

Setvar

Sets the antenna port.
! U1 setvar "rfid.reader_1.antenna_port" "value"
Values (ZT400 and ZT600 Series only)
E1
E2
E3
E4
D1
D2
D3
D4
C1
C2
C3
C4
B1
B2
B3
B4
A1
A2
A3
A4
ZT400 Antenna Array
Values (R110Xi4 only)
NA
F2
F3
F4
NA
E2
E3
E4
NA
D2
D3
D4
C1
C2
C3
C4
A1
A2
A3
A4
R110Xi4 Antenna Array
Default
"A4"

Getvar

Retrieves the current antenna port. 
! U1 getvar "rfid.reader_1.antenna_port"
Example
This
setvar
 example shows the selection of antenna port D3.
! U1 setvar "rfid.reader_1.antenna_port" "D3"
When the
setvar
 value is set to
"D3"
, the
getvar
 result is
"D3"
.