1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  3. ZPL Commands
  4. ^SI
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
^SI

^SI

The
^SI
 command is used to change the values for the media sensors, which are also set during the media calibration process. The media calibration process is described in your specific printer’s user’s guide.

Set Sensor Intensity

This command is available only for printers with firmware versions V53.15.x or later.
Format:
^SIa,b
Parameters
Details
a =
 indicates the setting to modify
Values:
1 =
 transmissive sensor brightness setting
2 =
 transmissive sensor baseline setting
Default:
 must be an accepted value or the entire command is ignored
b =
 the value to use for the sensor being configured
The ranges for this parameter are the same for the accepted values in parameter
a
.
Values:
0
 to
196
Default:
 must be an accepted value or the entire command is ignored