1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  3. ZPL Commands
  4. ^SX
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
^SX

^SX

The
^SX
 command is used to configure the ZebraNet Alert System.

Set ZebraNet Alert

Format:
^SXa,b,c,d,e,f
The values in this table apply to firmware version V48.12.4 or later.
Parameters
Details
a =
 condition type
Values:
A =
 paper out
B =
 ribbon out
C =
 printhead over-temp
D =
 printhead under-temp
E =
 head open
F =
 power supply over-temp
G =
 ribbon-in warning (Direct Thermal Mode)
H =
 rewind full
I =
 cut error
J =
 printer paused
K =
 PQ job completed
L =
 label ready
M =
 head element out
N =
 ZBI (Zebra BASIC Interpreter) runtime error
O =
 ZBI (Zebra BASIC Interpreter) forced error
P =
 power on
Q =
 clean printhead
R =
 media low
S =
 ribbon low
T =
 replace head
U =
 battery low
V =
 RFID error (in RFID printers only)
* =
 all errors
Default:
 if the parameter is missing or invalid, the command is ignored
b =
 destination for route alert
Values:
A =
 serial port
B* =
 parallel port
C =
 e-mail address
D =
 TCP/IP
E =
 UDP/IP
F =
 SNMP trap
Default:
 If this parameter is missing or invalid, the command is ignored.
* Requires
 bidirectional communication.
c =
 enable condition set alert to this destination
Values:
N =
 no
Y =
 yes
Values:
Y
 or previously configured value
d =
 enable condition clear alert to this destination
Values:
N =
 no
Y =
 yes
Values:
N
 or previously configured value
Parameters
e
 and
f
 are sub-options based on destination. If the sub-options are missing or invalid, these parameters are ignored.
e =
 destination setting
Values:
Internet e-mail address (e.g. user@company.com)
IP address (for example, 10.1.2.123)
SNMP trap
IP or IPX addresses
f =
 port number
Values:
TCP port # (
0
 to
65535
)
UPD port # (
0
 to
65535
)
Example:
 This is an example of the different (
b
) destinations that you can send for the condition type (
a
):
Serial:
^SXA,A,Y,Y
Parallel:
^SXA,B,Y,Y
E-Mail:
^SXA,C,Y,Y,admin@company.com
TCP:
^SXA,D,Y,Y,123.45.67.89,1234
UDP:
^SXA,E,Y,Y,123.45.67.89,1234
SNMP Trap:
^SXA,F,Y,Y,255.255.255.255
Comments:
 In the example above for SNMP Trap, entering 255.255.255.255 broadcasts the notification to every SNMP manager on the network. To route the device to a single SNMP manager, enter a specific address (123.45.67.89).