1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  3. ZPL Network Commands
  4. ^NS
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
^NS

^NS

Use this command to change the wired print server network settings.

Change Wired Networking Settings

Format:
^NSa,b,c,d,e,f,g,h,i
Parameters
Details
a
 = IP resolution
Values:
A = ALL
B = BOOTP
C = DHCP AND BOOTP
D = DHCP
G = GLEANING ONLY
R = RARP
P = PERMANENT
Default:
A
Use of GLEANING ONLY is not recommended when the Wireless Print Server or Wireless Plus Print Server is installed
b
 = IP address
Values:
 Any properly formatted IP address in the xxx.xxx.xxx.xxx format.
c
 = subnet mask
Values:
 Any properly formatted subnet mask in the xxx.xxx.xxx.xxx format.
d
 = default gateway
Values:
 Any properly formatted gateway in the xxx.xxx.xxx.xxx format.
e
 = WINS server address
Values:
 Any properly formatted WINS server in the xxx.xxx.xxx.xxx format.
f
 = connection timeout checking
Values:
Y =
 Yes
N =
 No
Default:
Y
g
 = timeout value
Time, in seconds, before the connection times out.
Values:
0
 through
9999
Default:
300
h
 = ARP broadcast interval
Time, in minutes, that the broadcast is sent to update the device’s ARP cache.
Values:
0
 through
30
Default:
0
 (no ARP sent)
i
 = base raw port number
The port number that the printer should use for its RAW data.
Values:
1
 through
65535
Default:
9100
Example: 
^XA
^NSa,192.168.0.1,255.255.255.0,192.168.0.2
^XZ
Comments:
For the Xi4, RXI4, ZM400/ZM600, and RZ400/RZ600 printers, Zebra recommends that you use the
^ND
 command instead of the
^NS
 command.