1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  3. ZPL Commands
  4. ^SQ
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
^SQ

^SQ

The
^SQ
 command is used to stop the ZebraNet Alert option.

Halt ZebraNet Alert

Format:
^SQa,b,c
Parameters
Details
a =
 condition type
Values:
A =
 paper out
B =
 ribbon out
C =
 printhead over-temp
D =
 printhead under-temp
E =
 head open
F =
 power supply over-temp
G =
 ribbon-in warning (Direct Thermal Mode)
H =
 rewind full
I =
 cut error
J =
 printer paused
K =
 PQ job completed
L =
 label ready
M =
 head element out
N =
 ZBI (Zebra BASIC Interpreter) runtime error
O =
 ZBI (Zebra BASIC Interpreter) forced error
Q =
 clean printhead
R =
 media low
S =
 ribbon low
T =
 replace head
U =
 battery low
V =
 RFID error (in RFID printers only)
W =
 all errors (in RFID printers only)
* =
 all errors (in non-RFID printers)
b =
 destination
Values:
A =
 serial port
B =
 parallel port
C =
 e-mail address
D =
 TCP/IP
E =
 UDP/IP
F =
 SNMP trap
* =
 wild card to stop alerts for all destinations
c =
 halt messages
Values:
Y =
 halt messages
N =
 start messages
Default:
Y