1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  3. ZPL Network Commands
  4. ^WS
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
^WS

^WS

Use this command to set the wireless radio card values for ESSID, Operating Mode, and Card Preamble.

Set Wireless Radio Card Values

Format:
^WSe,o,p,h,i,j,k
Parameters
Details
e
 = ESSID value
Values:
Any value up to 32 characters, including all ASCII and Extended ASCII characters, including the space character. When this parameter is left blank, the ESSID is not changed.
Default:
125
o
 = operating mode
Values:
I (Infrastructure), A (Adhoc)
Default:
I
p
 = wireless radio card preamble
Values:
L =
long
S =
short
Default:
L
h = wireless pulse
This parameter is supported in firmware version V60.15.x, V50.15.x, R6x.15.x, R53.15.x, ZSPx, or later.
Adds a pulse to the network traffic generated by the printer. This pulse is necessary with some network configurations to keep the printer online.
Values:
0 =
disabled
1 =
enabled
Default:
1
i = wireless pulse interval
This parameter is supported in firmware version V60.15.x, V50.15.x, R6x.15.x, R53.15.x, ZSPx, or later.
Sets the interval at which the wireless pulse is sent when the wireless pulse feature is enabled.
Values:
5 to 300 seconds
Default:
15
j = channel mask
This parameter is supported in firmware version X60.15.x, V50.15.x, or later.
For commonly used channel masks, see
Table 13 on page 424
.
Values:
4 Hexadecimal digits preceded by “0x” (0x0000 to 0xFFFF)
Default:
0x7FF
k = international mode
This parameter is supported in firmware version X60.15.x, V50.15.x, or later.
In international mode, the printer uses the channel set by the access point.
Values:
0 (Disabled), 1 (Enabled)
Default:
0
Channel Mask Settings
Region
Channel Mask
United States, Canada, Latin America
0x7FF
Europe, Middle East, Africa, other
0x1FFF
Japan
0x3FFF