The Connectivity Gateway operates in Single Shot, Continuous, or Level mode.
Ensure that you set up continuous mode between leader and followers before selecting an operating mode.
Navigate to the
Configuration
screen from the
Home
screen using the left navigation menu.
Use the bottom right
Run Mode
section on the
Configuration
screen to change between
Single Shot
,
Continuous
and
Level
modes.
Click
Config
to edit
Run Mode
settings.
Configure the required trigger settings:
Level Mode - determines how a level starts and stops.
Grace Period - the amount of time to wait after a level stop signal is received to accept incoming barcodes before rejecting them.
Output Mode - determines how barcodes are output over all configurable host interfaces while running in level mode.
Output Delimiter - determine the delimiting characters separating the barcode output after a level session when running in
Level End
output mode.
Click
Update
for the changes to take effect.
Observe the warning screen indicating that scan data is erased after the changes are implemented. Acknowledge the warning to proceed with your changes.
