1. MP72 Scanner Scale Integrator Guide
  2. Site Preparation and Installation
  3. Site Preparation
  4. Checkstand Preparation
  5. Tools
  • MP72 Scanner Scale Integrator Guide
Tools

Tools

No tools are required to install a MP72 without a scale or a Checkpoint antenna.
The following tools are required to mount the Scale Display:
  • Ruler (or similar measuring device)
  • Pencil (or similar measuring device)
  • Drill
  • 2.4 mm (3/32 in.) diameter drill bit (to make screw holes where display is to be mounted)
  • 19 mm (3/4 in.) diameter drill bit (to make cable pass through hole where display is to be mounted)
  • #2 Phillips screwdriver
If leveling screws are used on a small or medium MP72, a Phillips or flat blade screwdriver is needed.