1. MP72 Scanner Scale Integrator Guide
  2. Host Interfaces and Cable Pinouts
  3. USB Connections Interface
  4. Setting up the MP72
  • MP72 Scanner Scale Integrator Guide
Setting up the MP72

Setting up the MP72

Connect and configure the MP72 via USB.
  1. Connect the RJ-45 modular connector of the USB interface cable to the POS interface port on the MP72.
  2. Plug the series A connector or the Power Plus connector into the USB host. If Power Plus is used, the MP72 powers up with the POS.
  3. If no Power Plus is used, connect a 12V power supply. This immediately turns the MP72 on.
  4. Select the USB device type by scanning the appropriate barcode (see USB Device Type).
  5. Use one of the following methods to modify any parameter options:
    • 123Scan
    • 123Scan 2D configuration barcode
    • USB staging flash drive (see USB Staging Flash Drive)
    • Scan the appropriate barcodes in the MP72 Scanner Scale Barcode Programming Guide