1. MP72 Scanner Scale Integrator Guide
  2. Scale Calibration
  3. Calibrating the Scale
  4. Calibration at LOAD
  • MP72 Scanner Scale Integrator Guide
Calibration at LOAD

Calibration at LOAD

Continue calibration at LOAD after calibrating at NO LOAD.
Complete this calibration step within 30 seconds, or the calibration procedure exits.
The Scale Display blinks either CAL25 or CAL11, depending on the units of measure programmed (CAL25 = pounds; CAL11 = kilograms). The diagnostic 7-segment display scrolls C25Lb or C11g.
To continue with calibration:
  1. Depending on the units of measure programmed, place 25 lb or 11 kg on the scale. Group the weights in the center of the scale for best results.
    Center of Scale Location without and with Platter Installed
    If using 25 lb weights, place them on the scanner as shown; three 5 lb weights centered on the center of the scale, and two 5 lb weights centered on top.
    Weight Calibration Configuration for Pounds
    If using 11 kg weights, place them on the scanner as shown; two 5 kg weights centered on the center of the scale, and one 1 kg weight on top between the two 5 kg weights.
    Weight Calibration Configuration for Kilograms
  2. Press the Scale Zero button.
Continue calibration with Calibration Success or Failure.