1. MP72 Scanner Scale Integrator Guide
  2. Site Preparation and Installation
  3. Installing Components
  4. Installing the Customer Facing Scanner
  5. Installing the CFS Pole and Cable
  • MP72 Scanner Scale Integrator Guide
Installing the CFS Pole and Cable

Installing the CFS Pole and Cable

This section describes how to install the CFS pole and USB cable.
  1. Route the USB cable from the CFS through the opening in the MP72, ensuring the cable is vertical in the pole slot.
  2. Guide the CFS pole so the alignment pin on the pole enters the mating hole on the bracket.
  3. Attach the two T20 screws to mount the CFS pole to the bracket, and torque to 1.36 Nm +/- 0.03 (12 in-lb  +/- 0.25).
  4. Route the USB cable towards the MP72, through an open guiding slot in the CFS mount, pulling the cable taught when routing so it remains in the CFS pole slot after installation.
  5. Connect the USB cable to an open USB port.
    If the CFS is mounted on the opposite side of the MP72, the USB cable routes from the other direction.