1. MP72 Scanner Scale Integrator Guide
  2. Site Preparation and Installation
  3. Installing Components
  4. Scale Display
  5. Installing the Scale Display
  • MP72 Scanner Scale Integrator Guide
Installing the Scale Display

Installing the Scale Display

This section addresses how to install the scale display.
  1. Unpack the new Scale Display.
  2. Place the proper faceplate on the display.
    1. Fit the correct label on the Scale Display window. Select an overlay to ensure the proper weight units (kg or lb) that are required and parameters EXACTLY match the scale parameters printed on the scale Weights and Measures label. Depending on the unit and the country location, labels vary. You MUST match the label to the type of MP72 scale you are installing. (Labels, and instructions for their use, are packaged with the Scale Display.)
      • kg single interval
      • lb single interval
      • kg dual interval
      • kb single interval (with comma) for Brazil
    2. Remove adhesive backing and carefully secure on the front face of the display.
  3. Route the cable through the 19 mm hole in the countertop, or through the notch in the base of the display.
    The notch is usually located towards the rear, where it is less visible.
  4. Fasten the Scale Display to the countertop.
    1. Align the display over the countertop screw holes.
    2. Place a screw through each screw hole in the base of the display.
    3. Drive both screws into the counter until tight.
    4. Route the cable accordingly and connect the Scale Display cable to port 0.0 Scale Display on the MP72 before powering up the scanner/scale (see Connector Ports).
  5. Power on the MP72. The Scale Display presents the following test sequence:
    1. Displays 00.000 for 1.5 seconds, and then 99.999 for 1.5 seconds.
    2. Displays xx.xx0 lb or xx.xxx kg (based on the units selected) in normal operating mode.