1. MP72 Scanner Scale Integrator Guide
  2. Scale Calibration
  3. Calibrating the Scale
  4. Enter Calibration Mode
  5. Electronic Entry into Calibration Mode
  • MP72 Scanner Scale Integrator Guide
Electronic Entry into Calibration Mode

Electronic Entry into Calibration Mode

For scales sold without a mechanical calibration switch installed, perform an electronic calibration entry.
  1. Press and hold the Scale Zero and Volume buttons for five seconds until a short beep sounds, and then release the buttons.
  2. Within two seconds after releasing the buttons, press the Scale Zero and Volume buttons again and release.
    If calibration mode is entered successfully, the system sounds five long beeps. The optional Scale Display blinks CAL00 and CAL _ _ and the 7-segment display scrolls C00Lb or C00g. Continue to Program Legal Parameters.
    If Calibration Mode was not entered successfully, the scale remains in its current state.