Re-calibration Indications for Third Party Scales

Re-calibration Indications for Third Party Scales

The table below shows the indications for re-calibration states when used with a third party scale.
Re-calibration Indications With a Third Party Scale
Scale State
7-Segment Diagnostic Display
LED Indicators
Beeper Sequence
Successfully entering “Third-Party Scale Weight Guard Calibration Mode”.
"C00"
No Change
Five long beeps
Under zero
No Change
No Change
Two long beeps
Non-zero weight on the scale
No Change
No Change
Two long Beeps
Weight Guard Field Calibration Failed
"U36" - Speaker-side calibration failed
"U39" - Button-side calibration failed
No Change
Long low beep followed by long high beep
Successfully executing and exiting a Weight Guard Field Calibration
"CAL P" for 10 seconds
No Change
3 short beeps