1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. SGD Command Reference
  3. device.command_override.add
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
device.command_override.add

device.command_override.add

This command adds a specified command to the list of commands that will be ignored by the printer. The list is saved when the printer is powered off and is not cleared when the printer is defaulted.
  • If there are items in the list and the
    device.command_override.active
     is set to
    "yes"
    , then the config label will show
    ACTIVE COMMAND OVERRIDE.
  • If there are no items in the list or
    device.command_override.active
     is set to
    "no"
    , then the config label will show
    INACTIVE COMMAND OVERRIDE.

Setvar

To instruct the printer to add a specified command to the list of override commands:
! U1 setvar "device.command_override.add" "command"
Values
Any ZPL or Set/Get/Do command.
Default
NA
Example
When specifying a ZPL command, the command must be preceded by the current format or control prefix character (e.g.
^
 or
~
). Multiple commands must be declared with their own
setvar
 declaration.
! U1 setvar "device.command_override.add" "^MN" 
! U1 setvar "device.command_override.add" "^PR" 
! U1 setvar "device.command_override.add" "comm.baud" 
! U1 setvar "device.command_override.add" "device.reset"
The following example is not valid.
! U1 setvar "device.command_override.add" "~HI,~HS,^MN"
Instead, send the command as:
! U1 setvar "device.command_override.add" "~HI" 
! U1 setvar "device.command_override.add" "~HS" 
! U1 setvar "device.command_override.add" "^MN"
You cannot add
"device.command_override.clear"
 to the list of accepted override commands.