1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. SGD Wireless Commands
  3. ip.dhcp.enable
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
ip.dhcp.enable

ip.dhcp.enable

This printer setting turns DHCP on or off. DHCP is a method for acquiring an IP address, netmask, and gateway automatically on printer power-up. It requires a DHCP server on the local network.
If you are using static IP addressing, the IP protocol must be set to permanent.

Setvar

To instruct the printer to turn DHCP on or off:
! U1 setvar "ip.dhcp.enable" "value"
Values
  • "off"
     printer does not use DHCP to get the IP address
  • "on"
     printer uses DHCP to get the IP address
Default
"on"

Getvar

To instruct the printer to respond with the DHCP status:
! U1 getvar "ip.dhcp.enable"
Example
This
setvar
example shows the value set to
"on"
. 
! U1 setvar "ip.dhcp.enable" "on"
When the
setvar
 value is set to
"on"
, the
getvar
 result is
"on"
.