1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. SGD Wired Commands
  3. external_wired.ip.default_addr_enable
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
external_wired.ip.default_addr_enable

external_wired.ip.default_addr_enable

This command allows you to default the external wired print server’s IP address.
For a set IP address to take affect, the IP protocol must be set to permanent and the print server must be reset.

Setvar

To instruct the printer to use it’s default address:
! U1 setvar "external_wired.ip.default_addr_enable" "value"
If no address is provided through DHCP or BOOTP. If you do not assign an IP address after 2 minutes, the 10/100 Internal PS defaults to IP address 192.168.254.254.
Values
  • "on"
     enabled
  • "off"
     disabled
Default
"on"

Getvar

To instruct the printer to show the status of the setting of external wired print server’s default IP address feature:
! U1 getvar "external_wired.ip.default_addr_enable"
On SEH print server models PS102-Z or the PS105-Z, only the getvar command is supported.
Example
This
setvar
 example shows the value set to
"on"
. 
! U1 setvar "external_wired.ip.default_addr_enable" "on"
What the
setvar
 value is set to is the
getvar
 result. In this example, the
getvar
 result is
"on"
.