1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. SGD Wireless Commands
  3. wlan.ip.default_addr_enable
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
wlan.ip.default_addr_enable

wlan.ip.default_addr_enable

This command allows you to default the wireless print server’s IP address.
For a set IP address to take affect, the IP protocol must be set to permanent and the print server must be reset.

Setvar

To enable or disable te printer to use its default IP address, if no address is provided through DHCP or BOOTP:
! U1 setvar "wlan.ip.default_addr_enable" "value"
If you do not assign an IP address after 2 minutes, the 10/100 Internal PS defaults to IP address 192.168.254.254.
Values
  • "on"
     enabled
  • "off"
     disabled
Default
"on"

Getvar

To instruct the printer to show the status of the setting of the wireless print server’s default IP address feature:
! U1 getvar "wlan.ip.default_addr_enable"
Example
This
setvar
 example shows the value set to
"on"
. 
! U1 setvar "wlan.ip.default_addr_enable" "on"
What the
setvar
 value is set to is the
getvar
 result. In this example, the
getvar
 result is
"on"
.