1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. SGD Wireless Commands
  3. wlan.leap_password
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
wlan.leap_password

wlan.leap_password

This printer setting refers to the LEAP password. The password must correspond to a user profile established on the RADIUS/AAA server in use.
This parameter is not supported on units with a Frequency Hopping Spread Spectrum (FHSS) radio.

Setvar

This command instructs the printer to change the LEAP password.
! U1 setvar "wlan.leap_password" "values"
Values
0 to 32 ASCII characters
Default
"password"

Getvar

This command instructs the printer to respond with the LEAP password.
! U1 getvar "wlan.leap_password"
For protection, a single
"*"
prints.
Example
This setvar example shows the value set to
"password"
. 
! U1 setvar "wlan.leap_password" "password"
When the
setvar
 value is set to
"password"
, the
getvar
 result is
"*"
.