rfid.position.program

Setvar

! U1 setvar "rfid.position.program" "value" 

Values

"F0"
to
"Fxxx"
(where
xxx
is the label length in millimeters or
"999"
, whichever is less)
The printer prints the first part of a label until it reaches the specified distance and then begins programming. After programming, the printer prints the remainder of the label.
"B0"
to
"B30"
The printer backfeeds the label for the specified distance and then begins programming. To account for the backfeed, allow empty media liner to extend out of the front of the printer when using a backward programming position.
"up"
move to the next value
"down"
move to the previous value

Absolute Mode (all firmware versions)

xxxx=0
to label length (in dot rows). Move the media to the specified position xxxx on the label, measured in dot rows from the label top, before encoding. Set to 0 (no movement) if the tag is already in the effective area without moving the media.

Relative Mode (firmware versions V53.17.6 and later)

"F0"
to
"Fxxx"
(where xxx is the label length in millimeters or
999
, whichever is less)
The printer prints the first part of a label until it reaches the specified distance and then begins programming. After programming, the printer prints the remainder of the label.
"B0"
to
"B30"
(Does not apply to the RP4T printer.)
The printer backfeeds the label for the specified distance and then begins programming. To account for the backfeed, allow empty media liner to extend out of the front of the printer when using a backward programming position.

Default

For printers using V53.17.7 and later:
"F0"
(which moves the leading edge of the label to the print line)
For the R2844-Z and RPAX:
"0"
(no movement)
For all other printers or firmware: label length minus 1 mm (1/16 in.)

Getvar