1. ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
  2. SGD Wired Commands
  3. external_wired.ip.addr
  • ZPL II, ZBI 2, Set-Get-Do, Mirror, WML Programming Guide
external_wired.ip.addr

external_wired.ip.addr

This command allows you to get or set the external wired print server’s IP address.
For a set IP address to take affect, the IP protocol must be set to permanent and the print server must be reset.

Setvar

To instruct the printer to change its current external wired print server IP address upon powering the printer on:
! U1 setvar "external_wired.ip.addr" "value"
Values
Any valid IP address
Default
"0.0.0.0"

Getvar

To respond with the current external wired print server IP address:
! U1 getvar "external_wired.ip.addr"
On SEH print server models PS102-Z or the PS105-Z, only the getvar command is supported.
The
setvar
 value of this command can be affected by the
external_wired.ip.dhcp.enable
 command.
Example
This
setvar
 example shows the value set to
"10.14.4.235"
. 
! U1 setvar "external_wired.ip.addr" "10.14.4.235"
What the
setvar
 value is set to is the
getvar
 result. In this example, the
getvar
 result is
"10.14.4.235"
.